Pick a flat, smooth surface that has enough clearance above to pull out your lip product

• Test run your placement and try putting in & pulling out your lip product!

Clean and fully dry the chosen area thoroughly, making sure no dirt or residue is left behind

Peel away the thin top layer of the adhesive backing from the lip balm holder

Apply the holder onto the surface & press down to help the adhesive bond 

Wait a few hours before using

Unscrew the two factory screws holding down the console badge

If using your phone charger, pull the cord through the cable passthrough right below the swivel head

Line up the phone mount with the console badge on top, and screw back on the screws

Insert your charger cable through the cable passthrough opening

Test fit and line up the puck into the insert

Once you're familiar with the fit, remove the adhesive backing and press the puck into the slot

Press down and apply pressure for 30 seconds

Unscrew the two factory screws holding down the console badge

Plug in your charger

Line up the phone mount with the console badge on top, and screw back on the screws

Install in mild 70 degree weather

Recommend installing after a fresh car wash and/or cleaning the area right before

• • Use a cleaner that doesn't leave grease or residue behind

Before peeling away the adhesive backing, get a feel for the fit and familiarize yourself with how you'll place it 

• • Start by hooking on the outer corner

Once familiar, remove the adhesive backing carefully with clean hands

Apply, starting by hooking on the outer corner, and press down all sides to help the adhesive bond

Wait 3 days before getting wet